[chirp_users] Duplex "off" option

Amnon Zohar amnon.zohar at gmail.com
Fri Mar 10 09:45:32 PST 2017


split you set both freq
+ -  you set the offset

2017-03-10 18:45 GMT+02:00 Drew Einhorn <drew.einhorn at gmail.com>:

> In my configuration for a BaoFeng F8-HP there are 5 values for the Duplex
> setting (None, -, +, Split, Off)
>
> I believe + and - are variations of split.
>
> On Fri, Mar 10, 2017 at 9:22 AM John LaMartina ☀ <JohnLa at usa.net> wrote:
>
>> Duplex None = Tx / Rx on the same freq = Simplex
>> Duplex Split = Tx / Rx on split freq = Repeater
>> Duplex Off = Rx only = No Transmit
>>
>> John
>> Http://www.miklor.com
>>
>> On Mar 10, 2017, at 10:53 AM, Doyle Pugmire <sambopugmire at gmail.com>
>> wrote:
>>
>> I have the Baofeng 82-hp.  After reading the conversation below, I set my
>> radio on a local police frequency that is programed with “Duplex” set to
>> None and tested it to make sure I wouldn’t transmit on it.  I pressed the
>> transmit button and the red light on top came on  and the transmit
>> indicator on the screen  showed it was transmitting.  From what I have read
>> that means it is transmitting.  Wouldn’t the radio transmit if I only
>> selected “split”?
>>
>>
>> On Mar 9, 2017, at 9:47 PM, Mike Kartchner <masterwulfe at gmail.com> wrote:
>>
>> Simple test press the tx an see if your red indicator light come on (if
>> not it is not broadcasting)
>> but I have noticed in some cases (if before you set it to off) it was at
>> + or -, it will not reset to that same + or -, it will go to o in some
>> repeater cases that need that + or - setting an the off set factor.
>>
>> On Thu, Mar 9, 2017 at 4:47 PM, Richard B. Booth <cqw6rkk at gmail.com> wrot
>> e:
>>
>> For the Baofeng UV-5R and variants……..when programming a simplex
>> frequency channel…… will setting the Duplex option in CHIRP to “Off” result
>> in suppressing the TX in simplex operations?
>>
>>
>>
>> The reason for asking is as follows: I have several police and fire freqs
>> programmed into my radios, i.e., simplex. I want to make sure that even if
>> I make a mistake and hit the TX key, I will not TX on these freqs.
>>
>>
>>
>> I have in the past programmed these memory channels using split mode and
>> setting the TX on a dummy freq well away from the agency RX/TX freq.
>>
>>
>>
>> Thanks for any help !!
>>
>>
>>
>>
>>
>>
>>
>> Notice: This message content and attachments are intended for the sole
>> use of the intended recipient(s).
>>
>> Any use by unauthorized persons is prohibited and may be unlawful.
>> Forwarding of this email without the
>>
>> permission of the sender, original sender, or author is not authorized.
>> Forwarding without permission negates
>>
>> all liability, stated or implied, as applicable to the sender, original
>> sender, or author.
>>
>>
>>
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Mike Kartchner at masterwulfe at gmail.com
>> To unsubscribe, send an email to chirp_users-unsubscribe@
>> intrepid.danplanet.com
>>
>>
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Doyle  at sambopugmire at gmail.com
>> To unsubscribe, send an email to chirp_users-unsubscribe@
>> intrepid.danplanet.com
>>
>>
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>
>> This message was sent to John LaMartina at johnla at usa.net
>>
>>
>> To unsubscribe, send an email to chirp_users-unsubscribe@
>> intrepid.danplanet.com
>>
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Drew Einhorn at drew.einhorn at gmail.com
>> To unsubscribe, send an email to chirp_users-unsubscribe@
>> intrepid.danplanet.com
>
> --
> I don't remember, I don't recall
> I got no memory of anything at all
>     -- Peter Gabriel
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to amnon at amnon.zohar at gmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe@
> intrepid.danplanet.com
>



-- 
Amnon
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170310/56b13a6b/attachment-0002.html 


More information about the chirp_users mailing list