[chirp_users] "radio did not respond"

Bill Walter bllwltr at gmail.com
Fri Jul 28 11:41:38 PDT 2017


Paul,
     Remove and reinsert the connector on the F8-hp.  I recently purchased the unit and I found the connector to be too snug to go all the way in at first.  It becomes easier to work with in time.
Bill
N4DHP	
> On Jul 28, 2017, at 2:25 PM, Paul Veltman <stumpie1 at sbcglobal.net> wrote:
> 
> Hello all,
> 
> I received a list error message that my post to the list was denied so I 
> am posting it again.  I apologize if it got posted twice.
> 
> I just purchased a BaoFeng BF-F8HP and am trying to program it with 
> Chirp.  I followed the instructions and a pop up said "cloning" Then an 
> error message popped up that said "radio did not respond."  What am I 
> doing wrong here?  I am using the BaoFengTech FTDI cable on a windows 10 
> platform.
> 
> TIA for any advice.
> 
> Paul
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to BillW at n4dhp at arrl.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com




More information about the chirp_users mailing list