[chirp_users] New Daily Build

Walt Childson wchildson at gmail.com
Sun Jan 8 16:55:51 PST 2017


I've seen so many email threads discussing the seating of the cable into
the radio. Mine did not fit very well into my radio until I took a razor
blade and cut a little bit of the rubber out of the corner of the
connector. I have had no problems with that cable since. You need to feel
that cable clicking into the radio and if you cut that excess rubber out of
the way, then you will get that verification confirmation.

Walt
N6STM
73

On Jan 8, 2017 2:00 PM, "Rich Messeder" <rich.messeder at gmail.com> wrote:

> Greetings Harsha,
> When I first started w the Baofeng, I had cable trouble. I was advised to
> make sure that the connector to the radio was well seated. I checked it and
> it seemed fine. After several failed attempts, I took special care to see
> how well it seated, and found that it really must be /firmly/ pushed in to
> be fully seated. Since then, no problems with several releases of CHIRP.
>
> ~R~ NE1EE
> Rich Messeder
> Short email? No html? Here's why: http://emailcharter.org/
>
> On 2017-01-08 10:30:-0700, Harsha Godavari wrote:
> >Thank you. Downloaded the 0161018 version and received the message, "An
> error occurred Radio did not respond".
> >
> >Somewhere there was a suggestion that the programming cable might need
> some surgery ! At this point I don't feel brave enough :-)
> >
> >Regards
> >harsha godavari
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Walt Childson at wchildson at gmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe@
> intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170108/98d2ddf6/attachment-0002.html 


More information about the chirp_users mailing list