[chirp_users] Uv-5001 won't connect

[Pavel Milanes (CO7WT)]

El 29/04/16 a las 21:27, Jim Unroe escribió:
> On Fri, Apr 29, 2016 at 8:43 PM, Justin <700hpvette1 at cox.net> wrote:
>> So I made Y- harness per the wiring on the Miklor.com page. I've continuity
>> checked it a thousand times and all I get is about 3 seconds of status bar,
>> then, "radio didn't entered (sic) in the clone mode". I can connect fine
>> with the same cable (no Y-harness) to my UV-82hp. I tried to attach a photo
>> of the harness but it got rejected. Unless I'm reading the diagrams wrong, I
>> don't know what the issue is. One wire going to the 3.5mm socket, 2 going to
>> the 2.5mm socket, those 3 into the 3.5mm male. Am I missing something?
> Swap the RX and TX wires at the plug. The schematics usually just say
> RX Data and you don't know if it is RX data at the cable connecting to
> TX data at the radio or RX data at the radio going to TX data at the
> cable. You have to try both ways.
>
> Jim
>
There is always the possibility of a new variant of the radio...

Pavel.