[chirp_users] Are memories stored in the UV-5 editable at runtime?

[Rich Messeder]

This question is prompted by the discussion below, and by my surprise at finding that I had set the power to LOW when the memory was programmed to HIGH, and it quickly reverted to HIGH. I soon learned about using the keypad to change it at runtime. I have since reprogrammed all my powers to LOW.

~R~ NE1EE

On 2016-04-25 17:12:-0400, you wrote:
>On Mon, Apr 25, 2016 at 1:33 PM, kc6iih via chirp_users
><chirp_users at intrepid.danplanet.com> wrote:
>> Tone mode in simplex has no effect.
>> You are not using a repeater .
>> To further the point, tone no matter the setting won't  do anything unless
>> the repeater is using a tone. In that case you must have it set correctly.
>>
>> Jock  KC6IIH
>
>Tone Mode are just as effective when using simplex as it is using a
>repeater. Although tones are seldom used on ham frequencies when using
>simplex, their use on commercial simplex channels is quite common and
>CHIRP supports it fully.
>
>Jim KC9HI