[chirp_users] 70MHz channels

[Simon Rodda]

In answer to the resonses, but in no particular order:

The radio supports it; I can set these frequencies manually. I downloaded
from the radio first, then populated that.

>From that, I can see in Settings, Model Info, values in "60MHz Rx Start"
[and corresponding End / TX Start & End] of 66 --> 88 MHz

- SR

On 14 October 2015 at 16:03, Jardy Dawson via chirp_users <
chirp_users at intrepid.danplanet.com> wrote:

> CHIRP isn't  going to know what radio you have unless you read from the
> radio first.  Then you can find out if the frequency is supported or not.
>
> Jardy Dawson
> WA7JRD Ham Radio
>
> Sent by hurling dead pigeons over the wall by trebuchet.
>
> ------------------------------
> *From:* Simon Rodda <simon at simonrodda.com>
> *To:* chirp_users at intrepid.danplanet.com
> *Sent:* Wednesday, October 14, 2015 7:11 AM
> *Subject:* [chirp_users] 70MHz channels
>
> I'm using a TYT 9800, which supports 66-80MHz, I think.
>
> I've been trying to set frequencies within this range, but CHIRP complains
> that they are out of supported range. I'm guessing that msg comes from
> CHIRP, not the radio, since it isn't connected at the time.
>
> Regards,
> SR
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20151014/821930cc/attachment.html