[chirp_users] UV-5R / BF-F8+
Pavel Milanes Costa
Tue Aug 4 17:38:09 PDT 2015
Let's do math !
453.5625 - 453.5500 = 12.5 Khz spacing... aka: to close
Even a few Kenwood/Yaesu/Icom will slip here if the tower is close (and
even more if it uses high power) as Bob says.
Mind a humble little baofeng toy...
You must change the PL/DCT and/or move far from at least 25 Khz.
my 2c, 73 from CO7WT.
El 04/08/15 a las 09:06, Bob Burkett escribió:
> What should I expect for the cost! :)
>
> On Tue, Aug 4, 2015 at 1:39 AM, W Paul Mills <AC0HY at wpmills.com
> <mailto:AC0HY at wpmills.com>> wrote:
>
> These receivers are no where near good enough to handle spacing this
> close on receive.
>
> On 08/03/2015 09:14 PM, Bob Burkett wrote:
> > Tower is relatively close... PLs are the same
> >
> > ~Bob
> >
> > On Mon, Aug 3, 2015 at 9:59 PM, Ryan Tourge <ryan.tourge at gmail.com <mailto:ryan.tourge at gmail.com>
> > <mailto:ryan.tourge at gmail.com <mailto:ryan.tourge at gmail.com>>> wrote:
> >
> > If the adjacent signal is strong enough that will happen. Remember
> > these are $40 radios. Can you enable PL for that frequency?
> >
> >
> > On Mon, Aug 3, 2015 at 9:46 PM, Bob Burkett <r.l.burkett at gmail.com <mailto:r.l.burkett at gmail.com>
> > <mailto:r.l.burkett at gmail.com <mailto:r.l.burkett at gmail.com>>> wrote:
> >
> > I seem to now have CHIRP programming issues worked out
> > finally!... but now I have another issue!
> >
> > While monitoring a service on 453.5625 I get bleed over from a
> > service on 453.5500. I have entries set for NFN (narrow FM),
> >
> > Any ideas from anyone? Setting or bad radio??
> >
> > Thanks,
> > Bob/KF3BY
> >
>
> --
> /*************************************************
> * Amateur Radio Station AC0HY *
> * W. Paul Mills SN807 *
> * Assistant EC Alpha-1 ARES Shawnee/Wabunsee, KS *
> * President Kaw Valley Amateur Radio Club *
> *************************************************/
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> <mailto:chirp_users at intrepid.danplanet.com>
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
> <mailto:chirp_users-unsubscribe at intrepid.danplanet.com>
>
>
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
>
More information about the chirp_users
mailing list