[chirp_users] Dstar ID-RP4000V Repeater

Jim Unroe rock.unroe at gmail.com
Sun Nov 9 12:26:28 PST 2014


Bob,

The CHIRP driver is idrp.py and for some reason it does not show up as
a choice in CHIRP (I believe it should be "ID-2000V/4000V/2D/2V").
Most of the activity of this driver appears to be from 2009 to 2012. I
installed a daily build from May of 2012 and March of 2012 and there
was still not a selection for this Icom model.

Jim KC9HI

On Sat, Nov 8, 2014 at 11:35 PM, Robert Keeton <rkeeton at blarg.net> wrote:
> I have an ICOM , ID-RP4000V Dstar repeater.  According to the Wiki page both
> the VHF and UHF repeater is supported.  When I check the daily build list it
> is not shown as supported and I could not locate a *.py file for the
> repeater.  I have been through the archives and found reference that support
> for the ID-RP400V was added and it was working , but not much other info.
> When I run Chirp to try detect the repeater/radio I get an error message “
> An error has occurred Unable to get radio model”.  I have tried both the
> most up to date windows version and a USB thumb drive with the Live CD
> loaded.  Both versions operate fine , but with the error message.  Any
> suggestions????
>
> Bob K7MHJ
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>



More information about the chirp_users mailing list