[chirp_users] Adding frequencies outside of band plan

[Jens J.]

TM-241A isnt supported by chirp - and I dont even think it supports programming - it's only 20 channels.
Perhaps you meant TM-271A ?




________________________________
 From: Milton <thecanesvenatici at gmail.com>
To: Discussion of CHIRP <chirp_users at intrepid.danplanet.com> 
Sent: Tuesday, May 13, 2014 4:32 PM
Subject: Re: [chirp_users] Adding frequencies outside of band plan
 


I think the step would be 12.5 khz. And the USA version of the 241 stops at 148 mhz. 




On Tue, May 13, 2014 at 3:11 PM, Rob Cartier <rob.cartier at gmail.com> wrote:


>
>I have a Kenwood TM-241 that is able to handle frequencies that are able to 
>be resolved correctly in the Kenwood MCP-1A programmer however chirp complains 
>about the band and steps
>
>
>the frequency is 15x.5625.
>
>
>Is there a workaround to disable the test and enter the frequency
>
>
>Thanks
>  
>
>
>Rob - kd1jg
>_______________________________________________
>chirp_users mailing list
>chirp_users at intrepid.danplanet.com
>http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>
>


_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20140513/fd827a44/attachment.html