[chirp_users] Baofeng UV-5R programming

[Jim Unroe]

On Tue, Jan 7, 2014 at 11:06 AM, kdufour . <kdufour at gmail.com> wrote:

> am running 2.0.2.1 for XP
>
>
>
If you are running this driver on XP and getting the "radio did not
respond" error, then there are two possibilities. Either the programming
cable is not fully plugged into the radio (the most likely cause) or the
programming cable is defective (possible but not as likely).

Many users swear that their programming cable is fully plugged in but are
amazed when they give it a wiggle and a firm push and notice it go in just
a little further. See the "Errors and Error Messages" page on the
miklor.comwebsite.

http://www.miklor.com/HT/HT-ErrorMess.php#error1

Jim KC9HI
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20140107/2ab78112/attachment.html