[chirp_users] Baofeng V6
W4GRJ
Thu Jan 2 19:22:44 PST 2014
Mike,
Can you send me or post the link to the BF-480 software.
Thanks,
Jack
On Jan 2, 2014, at 9:01 PM, Michael Walker <va3mw at portcredit.net> wrote:
Hi Jim
I did try Chirp and the BF-888, but I got a radio mismatch error (or something like that). I'm not near the computer at the moment.
Chirp does a hard check to make sure it is the radio it thinks it is.
Mike va3mw
> On Thu, Jan 2, 2014 at 6:39 PM, Jim Unroe <rock.unroe at gmail.com> wrote:
>> On Thu, Jan 2, 2014 at 4:10 PM, Michael Walker <va3mw at portcredit.net> wrote:
>> OK, I figured this out. A typical very stupid user error.
>>
>> The correct software is their BF-480 software.
>>
>> Setup up the com port, pick BF-480 and the VHF or UHF frequency range you want.
>>
>> Select Read from Radio.
>>
>> Next, pops up the 'BAR' that we are used to seeing. For old farts like me, I just sat their and stared at it. For a LONG time. Days, weeks. :)
>>
>> It never occurred to me to hit the OK button. I did get pretty good at hitting the Cancel button though. :)
>>
>> Ok, head between legs.
>>
>> As you were.... Mike va3mw
>>
>> <image.png>
>>
>>
>>> On Sat, Dec 28, 2013 at 10:23 PM, Michael Walker <va3mw at portcredit.net> wrote:
>>> Thanks John
>>>
>>> I have seen that as well. For the one that I get a Chinese Character set, I have been able to change to English. The one program I think that can do it has Zero characters on it (english or chinese) and everything is replaced by a ???.
>>>
>>> Again, I apologize for taking up the space on the Chirp reflector.
>>>
>>> The best I can tell is that the actual program is called BF-480 based on what I found on 409Shoppe's site.
>>>
>>> I know the port and the cable work as I can use the same cable and same port (FTDI) to read my UV-5R with Chirp. I also know they aren't holding open the port as I do close down Chirp before testing. I have even tried after a reboot with the BF-480 software being the first code used.
>>>
>>> My note to self will be to check the Chirp support hardware list first before ordering new hardware! :)
>>>
>>> Mike va3mw
>
> Baofeng BF-888s radios used to be programmed with this same BF-480 software. So if the Baofeng BF-480 software works for the the UV-6, then it would be worth a shot to try the selecting the BF-888s driver in CHIRP. Let us know if it works or not.
>
> Jim KC9HI
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20140102/02230067/attachment.html
More information about the chirp_users
mailing list