[chirp_users] FT-817 problem

[Dale Urban]

Well I tried the older driver with the same results. Any other ides where to look for a fix?

Sent from my iPad

> On Dec 14, 2014, at 12:06, Dale Urban <chiefsfan2 at cox.net> wrote:
> 
> Thank you I'll give it a try.
> 
> Sent from my iPad
> 
>> On Dec 13, 2014, at 19:25, Jim Unroe <rock.unroe at gmail.com> wrote:
>> 
>> Hi Dale,
>> 
>> The usual problem is that most programming cable that have Prolific
>> type chips in them are not compatible with the latest Windows drivers.
>> The fix is to downgrade to the v3.2.0.0 driver.
>> 
>> http://www.miklor.com/COM/UV_Drivers.php
>> 
>> Jim KC9HI
>> 
>>> On Sat, Dec 13, 2014 at 7:59 PM, Dale Urban <chiefsfan2 at cox.net> wrote:
>>> I purchased a USB cable for my FT-817 from kawamall to use with chirp. The device mgr says the drivers are up to date and the device is working properly on on com port 12. I have the 817 cat data speed set at 9600 and the com port setting is 9600,8,N,1 with no flow control. I follow the instructions in cirp to download from radio and it just sets there and will not read the radio and eventually will get a no communications with the radio error msg.  If I shut the radio off chirp then sends an error so it knows the radio is there. I did notice in the txt file that was with the drivers says the drivers are for a gps? Any suggestions to try would be appreciated. Thanks
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users