w4grj at satterfield.org
Thu Aug 14 11:45:05 PDT 2014
That did it, I ground out the underside of the connector.
Now works perfect.
From: chirp_users-bounces at intrepid.danplanet.com
[mailto:chirp_users-bounces at intrepid.danplanet.com] On Behalf Of Aubrey
Sent: Wednesday, August 13, 2014 5:30 PM
To: chirp_users at intrepid.danplanet.com
Subject: Re: [chirp_users] GT-3
The issue of the cable seating in the radio is especially likely with the
GT-3, as it has rounded sides which can prevent the cable from seating. I
had to use a knife to trim my cable before it would work with the GT-3.
On 08/13/2014 04:18 PM, Jim Unroe wrote:
On Wed, Aug 13, 2014 at 4:57 PM, w4grj <w4grj at satterfield.org> wrote:
Tried using UV-5R setting on my new GT-3 but it does not communicate with
1. Make sure you have a compatible driver installed. Programming cables with
Prolific chips almost always require you to use an older or patched driver
to be compatible.
Windows XP: V22.214.171.124
Windows Vista, 7, 8, 8.1: V126.96.36.199
Mac OS X
http://chirp.danplanet.com/projects/chirp/wiki/MacOS_Tips (generic drivers)
Compatible drivers are often already installed. Give CHIRP Live CD a try
(you can "burn" it to a USB flash drive). Since the OS is Xubuntu Linux, if
this works with your programming cable and Windows or OS X doesn't work, you
have at least determined the problem is not your programming cable or CHIRP.
2. Make sure the cable is fully plugged into the radio. This trips up a lot
of owners of the UV-5R (and variants like the GT-3).
chirp_users mailing list
chirp_users at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the chirp_users