[chirp_users] (no subject)

[chirp at ampmonkeys.com]

opps, Thank you, working now.


On Fri, August 22, 2014 3:54 pm, Jim Unroe wrote:
> Install the v3.2.0.0 driver per the instructions here.
>
>
> http://www.miklor.com/COM/UV_Drivers.php
>
>
> Jim KC9HI
>
>
>
> On Fri, Aug 22, 2014 at 6:44 PM, <chirp at ampmonkeys.com> wrote:
>
>
>> Hello,
>> I am nat able to download from my radio using Chrip. My radio is a
>> Baofeng uv-82. It is a new radio and I am new to chirp. My OS is
>> windows 7. The cable is a usb programming cable form Baofeng via amazon.
>>
>> The cable drivers are installed corectly. I can open the com port under
>>  Tera Term and shorting the TX and RX contacts togethter I can get it
>> echo what I type. I can also probe the connection and see resonable data
>> on the O-scope.
>>
>>
>> I have tryed the stable as well as the nightly build of chirp. When I
>> try to download I get the error "the radio did not respond". It is hard
>> to see but I think the cable is seated al the way in. With just the
>> cable and tuning on the radio, It will not key but as soon as i plug the
>> usb cable in the radio will key.
>>
>> I have also tried to download from the radio on "copying" mode by
>> holding down the 2 key while turning on the power. If I do this with
>> tera term opend to the right com port I get a repeating set of bytes
>> that look to be binary (garbaled ascii chars).
>>
>> Any Ideas?
>>
>>
>> thanks,
>>
>> kk6onl
>>
>>
>>
>> _______________________________________________
>> chirp_users mailing list chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>
>>
> _______________________________________________
> chirp_users mailing list chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>
>