[chirp_users] Yaesu FT-7900R driver needed. I think :)
apple2gs at sbcglobal.net
Mon Mar 11 17:46:54 PDT 2013
Okay. First thank you and Dan so much!! :)
Well, I got CHIRP to see the radio, after following what you said (I feel soooooo dumb, I should have re-read that stuff) thanks.
I got CHIRp to download from the 7900.
I then input some channels from the Repeater Book input.
The channels went in to the CHIRP spread sheet.
I then tried to upload back to the radio……………..
THis it what it says now:
Radio did not ack block at 0
On Mar 11, 2013, at 7:10 PM, Tom Hayward <esarfl at gmail.com> wrote:
> On Mon, Mar 11, 2013 at 3:50 PM, Apple //GS <apple2gs at sbcglobal.net> wrote:
>> I turned the radio on while holding the "MHz/PRI" button. Then turned the dial to F-7 CLONE
>> Should I do something else?
> You missed a step. Page 66 of your manual:
> To clone from one transceiver to a computer, use the following procedure:
> 1. Insert the Cloning Cable into the DATA jack of the transceiver.
> 2. Turn transceiver off, then press and hold in the [MHz(PRI)] key
> while turning the power on again.
> 3. Rotate the DIAL knob on each radio to select (F-7 CLONE), then
> press and hold in the [BAND(SET)] key. The display will disappear for
> a moment, then the “CLONE” notation will appear on the display.
> 4. In Chirp, select Download From Radio
> 5. Now, on the “Source” radio, press the [V/M(MW)] key. The “- - TX -
> -” indicator will appear on the display, and the cloning data transfer
> will immediately begin.
> 6. If there is a problem during the cloning process, “ERROR” will be
> displayed. Check your cable connections, and try again.
> 7. If cloning was successful, “CLONE” will reappear the radio display.
> Chirp will present your memory channels in a spreadsheet format.
> Tom KD7LXL
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
More information about the chirp_users