[chirp_users] Channel program problem

[Jim Unroe]

Bill,
With CHIRP set the following columns up as shown below

Frequency=147.180000
Tone Mode=Tone
Tone=151.4
Duplex=+
Offset=0.600000
Mode=FM
Power=Low or High

Jim

On Sun, Jan 20, 2013 at 5:59 PM, Bill Gabbard <wcgabbard1 at windstream.net>wrote:

> **
> I've a Baofeng UV-5RA and when importing local repeaters in Chirp (only
> been
> using since 1/11 & VIP before then & same problem), in Channel Mode it
> will
> not ping one of 4 local repeaters but if I set it in VFO Mode, no
> problems.
> In Channel Mode, I can hear other local repeaters but one I've programmed;
> RX Freq.=147.180
> TX Freq.=147.780
> Tone=151.4
> Offset=00.600
>
> FYI, I've 2 other Ts, a Yaseau FT-11 & a B-K LPH-5142 of which both can
> get
> the repeater, I can't talk to either of these from my Baofeng While in
> Channel Mode but can in VFO Mode.
> Any suggestions appreciated.
> 73s
> Bill
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20130120/dddd65b9/attachment.html