[chirp_users] Tuning step roadblock

Jim Unroe rock.unroe at gmail.com
Sun Dec 8 06:22:32 PST 2013


On Sun, Dec 8, 2013 at 3:43 AM, ddubois <woody2 at questiongravity.com> wrote:

>
> Here's what I'm stuck on. I took an image off the Baofeng to use as a
> template. I'm trying to enter the RX freq of 156.2025 into the first
> memory channel. When I do so, I get the error "Tuning step 2.50 not
> supported...Frequency requires 2.50kHz step." I need to configure the
> channel to receive on 159.000, figured I'd set Duplex to Split and set
> Offset to 159.000. I'll spare you all the work-arounds I've tried, and
> the other errors I've seen, 'cause I'm starting to wonder if my radio
> won't support this "step", and I'm left to wonder what the heck "Tune
> step" and "channelize" are anyway? I've looked in the wiki, and done
> some web searching, but so far no joy. Any light would be much appreciated!
>
> Thanks much,
> Doug, Kansas
>

Doug,
You are going about this in exactly the right way. Just use the older CHIRP
daily that I pointed out earlier to get the job done. I have submitted a
patch that will restore programming the UV-B5/B6 with CHIRP to a 2.5 KHz
resolution and still fix the issue the previous patch was intended to
address.
Jim KC9HI
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20131208/4f131827/attachment-0002.html 


More information about the chirp_users mailing list