[chirp_users] Chirp and radio parameters not agreeing

[Milton Hywatt]

On a long shot, have you tried a factory reset, a complete reset not just
some parameters. I forget is the UV5 has two different levels of reset.
Then upload your image to the radio and see what happens. I know from 
experience that radios which get all their operating instructions from 
the non volatile firmware which is stored along with modifiable ram
can get corrupted and cause some real whacky symptoms. If you have 
a current image of your channels give it a try. When the radio reboots
it will upload a fresh operating system from its firmware. Then 
you can upload your memory image.  Might be the simple fix and I certainly
would be the first to try it. 


________________________________
 From: Donald Stewart <djstewart at metrocast.net>
To: Discussion of CHIRP <chirp_users at intrepid.danplanet.com> 
Sent: Thursday, August 15, 2013 6:14 PM
Subject: Re: [chirp_users] Chirp and radio parameters not agreeing
 

Can't see an "R"  so still not sure.  Maybe have to come back to this later.


On 8/15/2013 6:06 PM, Andrew wrote:
> I've just had a test with my UV-5RA... This could happen if your
> channels are duplex frequencies and you have Reverse turned on - then it
> will be displaying the TX frequency not the RX frequency. If there's an
> "R" in the display, press "*" and it should return to normal.
>

_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20130815/32b6b61a/attachment.html