[chirp_users] Quick followup questions re: Mac setup (was re: chirp_users Digest, Vol 46, Issue 14)

Matthew J. Mason mason.matthew.j at gmail.com
Thu Oct 11 18:18:37 PDT 2012

Thanks Dan - A quick follow-up:

*You probably need to install the driver. See

Done - thanks.

*Use System Information -> USB to find your cable in the USB device
tree. If it's a Prolific device, you can try the open source driver
mentioned on that page...*

What's the syntax I need to use in Chirp to point it to the cable?  What
you're looking at below is what System Information is reporting for the
USB-to-Serial cable I'm using (Edgeport/1), plugged into a USB hub.  But
none of these elements seems to work as a port address in Chirp.  (I'm sure
I'm missing something really obvious...any help is appreciated.)

*Product ID: 0x0215
Vendor ID: 0x1608  (Inside Out Networks
Version: 0.01
Speed: Up to 12 Mb/sec
Manufacturer: Inside Out Networks
Location ID: 0xfd136000 / 6
Current Available (mA): 500
Current Required (mA): Unknown (Device has not been configured)

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20121011/272204be/attachment-0002.html 

More information about the chirp_users mailing list