[chirp_users] Quick followup questions re: Mac setup (was re: chirp_users Digest, Vol 46, Issue 14)

[Matthew J. Mason]

Thanks Dan - A quick follow-up:

*You probably need to install the driver. See
http://chirp.danplanet.com/projects/chirp/wiki/MacOS_Tips*

Done - thanks.

*Use System Information -> USB to find your cable in the USB device
tree. If it's a Prolific device, you can try the open source driver
mentioned on that page...*


What's the syntax I need to use in Chirp to point it to the cable?  What
you're looking at below is what System Information is reporting for the
USB-to-Serial cable I'm using (Edgeport/1), plugged into a USB hub.  But
none of these elements seems to work as a port address in Chirp.  (I'm sure
I'm missing something really obvious...any help is appreciated.)

*Edgeport/1:
*Product ID: 0x0215
Vendor ID: 0x1608  (Inside Out Networks
Version: 0.01
Speed: Up to 12 Mb/sec
Manufacturer: Inside Out Networks
Location ID: 0xfd136000 / 6
Current Available (mA): 500
Current Required (mA): Unknown (Device has not been configured)

>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20121011/272204be/attachment.html