[chirp_devel] FT70 Debug FIle

[Jim Unroe]

On Sun, Mar 18, 2018 at 1:22 PM, Fred Munden via chirp_devel
<chirp_devel at intrepid.danplanet.com> wrote:
> When I try to read from Ft70 I'm not seeing a debug.log file in
> %appdata%/chirp, trying to chase down Failed to communicate error message.
> I was under the impression that a debug file was always created.

That is where it is. Once you enter "%appdata%\" into the search box
(assuming you are following the method shown on the CHIRP "How To
Report Issues" page, you should see the "CHIRP" folder listed above in
the "Search programs and files" results.

Another method would be to enter "%appdata% into the Address Bar of
the Windows File Explorer and press [Enter]. This should select the
"C:\Users\{your_user_name}\AppData\Roaming" folder which should
contain the "CHIRP" folder.

If you don't see this folder, then CHIRP is most likely not fully
installed. You may have to perform the install by right-clicking the
installer file and choosing "Run as administrator".

Jim KC9HI