[chirp_devel] Yaesu FTM-10R

[Angus Ainslie]

On 2016-04-04 08:45, af5mi at yahoo.com wrote:
> I'm guessing if you looked at the raw wav/pcm in an audio editor like
> audacity, you could see the bytes in 0s and 1s, but that might take a
> while to completely reverse it ;)
> 

I looked at the spectrum analysis in audacity and nothing obvious jumped 
out.

> If you have one of those rtl-sdr dongles (who doesn't?) then you could
> use something like rtl_433 (meant for decoding various rf switch/wx
> station/etc signals), run it in analyze mode and point it to the
> frequency where this radio does its thing.
> 

Right ( I think I have 2 :) . I initially was going to go that way but 
then dropped it because it was only unidirectional but until I figure 
out the protocol that will work.