[chirp_devel] CHIRP programming

[Tom Hayward]

On Fri, Mar 22, 2013 at 1:22 PM, Ran Giladi <ran at bgu.ac.il> wrote:
> The FT1900R was in CLONE mode (same as 1802, i.e., on+A/N LOW), but failed to read.
> Where is the debug.log?

The console output is the debug log... you found it.

> I got this message  on the console:
>
> User selected Yaesu FT-1900R on port /dev/ttyUSB0
> Clone thread started
>
> -- Exception: --
> Traceback (most recent call last):
>   File "/home/ran/Downloads/chirp-0.3.0/chirpui/clone.py", line 225, in run
>     self.__radio.sync_in()
>   File "/home/ran/Downloads/chirp-0.3.0/chirp/yaesu_clone.py", line 199, in sync_in
>     self._mmap = _clone_in(self)
>   File "/home/ran/Downloads/chirp-0.3.0/chirp/yaesu_clone.py", line 84, in _clone_in
>     raise errors.RadioError("Failed to communicate with the radio: %s" % e)
> RadioError: Failed to communicate with the radio: No response from radio
> ------
> Clone failed: Failed to communicate with the radio: No response from radio
> Clone thread ended
> --- Exception Dialog: Failed to communicate with the radio: No response from radio ---
> None
> ----------------------------

This looks like you didn't attach the cable or didn't hit the button
on the radio to start the clone. When you started the clone on the
radio, did the progress bar (s-meter) on the radio advance until full,
then return to clone mode?

Tom KD7LXL