[chirp_devel] Quansheng Programming

[shawn]

Have you been able to successfully program the radio with the factory 
software?

If so, can you get a capture of that?

On 11/1/2012 7:32 PM, The Silver Fox wrote:
> Not sure but the trace of the program that works opens, closes and re-opens
> the connection before sending.  I have tried different baud rates, stop
> bits, and byte sizes but the radio does not seem to respond to the commands
> as it does in the serial tracing.
> 73,
> Alan - W6ARH
>
>
> -----Original Message-----
> From: chirp_devel-bounces at intrepid.danplanet.com
> [mailto:chirp_devel-bounces at intrepid.danplanet.com] On Behalf Of Dan Smith
> Sent: Thursday, November 01, 2012 6:38 PM
> To: chirp_devel at intrepid.danplanet.com
> Subject: Re: [chirp_devel] Quansheng Programming
>
>> I have yet to be successful opening a dialog with the radio.  I am
>> almost at the point of giving up.  The last thing for me to try is to
>> close the serial port and re-open it.  Rather than rooting through the
>> code I thought I would ask if this can be accomplished and how?
>
> Why do you think that will help? What sort of troubles are you running into?
>
> The serial port is opened right before it calls your driver:
>
> ser = serial.Serial(port=settings.port,
>                      baudrate=rclass.BAUD_RATE,
>                      rtscts=rclass.HARDWARE_FLOW,
>                      timeout=0.25)
>
> So, you can do that again in your driver for debugging if you think it will
> help. However, I'd encourage you to tell us what you've tried, what you've
> learned, and ask for help. There's a lot of collective knowledge about
> reverse engineering radios here :)
>
> --
> Dan Smith
> www.danplanet.com
> KK7DS
>
>
> _______________________________________________
> chirp_devel mailing list
> chirp_devel at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_devel
>


-- 
--Shawn
--KF7WXG